ZW4410FG-FT, Pompe hydraulique électrique, Dispositifs de bridage, Continuous Connection, Ecran LCD,0,82 l/min débit d'huile à 350 bar, 4/3 Distributeur électrique, 230V
ZW4410FG-FT, Pompe hydraulique électrique, Dispositifs de bridage, Continuous Connection, Ecran LCD,0,82 l/min débit d'huile à 350 bar, 4/3 Distributeur électrique, 230V
Modèle: ZW4410FG-FT | ECCN: EAR99 | Harmonization: 8413500070
Série: ZW | Gamme de Produits: Dispositifs de Bridage
Série: ZW | Gamme de Produits: Dispositifs de Bridage
- Automatic pressure control for continuous connection fixtures
- Programmable pressure setting allows pump to maintain system pressure continuously
- Includes pilot operated check valve ensuring pressure is maintained in circuit
- Z-Class high-efficiency pump design; featuring higher oil flow and by-pass pressure than comparable pumps
- High-strength, molded electrical enclosure protects electronics, power supplies and LCD readout from harsh industrial environments
- Efficient design reduces heat generation and reduces power consumption
- Balanced pump section reduces vibration improving durability and sound levels
- Back-lit LCD readout provides hour and cycle counts, low voltage warnings and pressure read-out when used with pressure transducer
- Low-voltage pendant on solenoid valve models with sealed switches improves operator safety
- Factory installed return line filter (25 micron) and pressure transducer
- The Enerpac Continuous Connection Pump provides two modes of operation:
- Manual mode: Pump runs continuously, building pressure as long as operator holds down pendant button
- AUTO mode: Pump runs continuously, maintaining user-set pressure window on clamp circuit as long as necessary
- Manual mode: The operator turns the pump motor on, and then presses and holds the up arrow on the pendant. When the button is released, the valve shifts to neutral, but pressure is maintained in the clamp circuit by the pilot-operated check valve. When the operator presses and holds the down arrow on the pendant, pressure in the clamp circuit will release, and the fixture will unclamp
- AUTO mode: The operator turns the pump motor on, and then presses and holds the up arrow on the pendant. When the customer-programmed HI PRESS setting is reached, the valve shifts to neutral, but pressure is maintained in the clamp circuit by the pilot-operated check valve. If pressure drops below the LO PRESS setting, the valve will re-activate and build pressure in the clamp circuit again. The pump will maintain this cycle until the operator presses and holds the down arrow on the pendant. When the down arrow is pressed, pressure in the clamp circuit will release, and the fixture will unclamp.